Shopping set

SMD and Hot Air Rework Bench

A 2-in-1 iron and hot air station, flux, tweezers, a vise and a graded practice board for surface-mount work.

Compiled by Kerem Başbuğ · Last updated October 20, 2026 · How we rank

Affiliate disclosure: As an Amazon Associate we earn from qualifying purchases. We may earn a commission when you buy through links on this page — at no extra cost to you. Read our affiliate disclosure for details.

Shopping set · 8 items

SMD and Hot Air Rework Bench

Surface-mount parts are too small to hold with fingers and too close together to solder without flux. This set is built around a combined iron and hot air station so you can both place parts and remove them, with the hand tools that make 0805 parts manageable and a practice board to learn on before touching a real device.

1. Iron + hot air

WEP 882D 2-in-1 Hot Air Rework & Soldering Station

Iron and hot air in one station — place parts with the iron, lift chips with the air.

Check Price → Read review
2. Flux

Kester 951 No-Clean Flux Pen

Surface-mount joints do not work dry; a stroke of flux pulls the solder onto the pad.

Check Price →
3. Tweezers

XOOL 9-Piece ESD Precision Tweezers

Fine ESD-safe tips for picking up and holding parts the size of a grain of rice.

Check Price →
4. Board holder

Stickvise PCB Vise

Holds the board flat and still so both hands are free for tweezers and iron.

Check Price →
5. Wick

TOWOT Solder Wick & Flux Kit

The only sensible way to clear a bridge between fine-pitch legs.

Check Price → Read review
6. Practice board

Gikfun SMD/SMT Welding Practice Board (EK7028)

Graded footprints from easy to tiny — learn where your limit is before it matters.

Check Price → Read review
7. Cleaner

MG Chemicals 99.9% Isopropyl Alcohol

Electronics-grade IPA that removes flux residue without leaving a film.

Check Price →
8. Magnifier

Kaisiking Helping Hands with Magnifier

Lit magnification for inspecting joints that are hard to judge with the naked eye.

Check Price → Read review

Get Set on Amazon →

Adds all 8 items to your Amazon cart in one step — remove anything you already own before checkout. We earn a commission on qualifying purchases, at no extra cost to you.

Why these 8 items

Hot air is what separates rework from assembly: it lets you lift a chip with all its legs at once instead of fighting one pad at a time. The WEP 882D puts an iron and a hot air gun in one unit, which saves bench space and money compared with two stations.

The rest of the set is about control. ESD-safe tweezers to place parts, a Stickvise to hold the board flat, a flux pen because surface-mount joints simply do not work dry, and wick for cleaning bridges off fine-pitch legs. Isopropyl alcohol cleans the flux residue off afterwards so the finished board does not stay sticky.

Start on the Gikfun SMD practice board rather than a real device: it has a range of footprints from large to very small so you can find your limit before it costs you a phone.

Read the full guide: SMD rework: hot air and reflow explained.

Frequently asked questions

Do I need hot air to solder SMD parts?

Not to solder them — a fine tip and flux handle most passives and chips with legs. You need hot air to remove multi-leg parts cleanly and to work with leadless packages, which is what rework usually means.

What hot air temperature should I start at?

Low: around 300–330°C with low airflow for small passives, more for larger chips. Add flux, keep the nozzle moving, and increase gradually. Our SMD rework guide has a starting-settings table.